Wardrobes R Us
ASSEMBLY INSTRUCTIONS
Flat Pack wardrobe organizers
Please read instructions carefully before assembly as this will save time and prevent damage.
Tools required;
Drill gun
Pozi drive bit
3-5mm drill bit
Philips screwdriver
After determining which wardrobe size you have purchased, the top and the cleat can be cut down to a smaller size if required e.g., you may have purchased a 2100 and your wardrobe gap is 2000 long, you only need to cut down one side of each (must be the same side) to the correct length.
Wardrobe Top
x = x
Cleat (fixing rail)
x = x
E.g. cut down accordingly
Check back wall for stud spacing’s, the
Wall cleat is pre-drilled at 600mm spacing
Step 1
Measure along back wall at a height of 2100mm from the floor, do this at each end and in the middle.
Step 2
Screw suspension bracket screws into the wall cleat.
Step 3
Hold wall cleat in position at the 2100mm height that has been marked on the back wall and pre-drill, and then screw 2 ½” screws to fasten the cleat to the wall.
Step 4
Screw the threaded euro screws to the desired shelf position; this will be determined on whether you want shoe height, stacking clothes or euro screws for placement of drawers.
Step 5
Hang uprights in desired position.
Step 6
Clip in the shelves. The shelves pull the sides together and tighten as they lock into place. Fit wardrobe rail brackets into position and then wardrobe rails.
Step 8 (if you are adding drawers)
Locate the carcass drawer runners and screw onto
The wardrobe ends at the desired drawer height,
The wheel goes at the front.
Connect the LH drawer side (white steel) to the back (white steel) then connect the RH drawer side (white steel) to the other end of the back. Place the drawer bottom into the drawer frame; work with the holes on the underside leading edge so that the lugs on the drawer sides fit into the holes of the drawer bottom. Place drawer into wardrobe unit.
Step 9
Place the drawer front face down with the holes facing up. You will see a pencil mark on the long edge of the drawer front; this should be away from you.
Step 10
Place the LH side drawer mounting bracket on the LH side of the drawer with the flat face in the centre and the same with the right side, screw brackets into drawer front.
Step 11
Connect the drawer front onto the drawer sides and tighten using Philips screw driver. These can be adjusted if needed up, down and from left to right. Drill and secure handles of your choice. Your Mr Shelf wardrobe is now finished and ready to be used.
Thank you for purchasing a Wardrobes R Us Wardrobe system